Do you notice excessive bouncing, sway or sag in your suspension while towing that camper, boat or equipment trailer with your pick-up truck? Adding a helper spring to your rear suspension will keep you riding smoothly while hauling those heavy loads.
A Timbren Kit Suspension Enhancement System is an affordable option for improving the suspension of your pick-up truck. Installing Timbren helper springs is easy, requires no special tools and can be done in just a few minutes by almost anyone.
A 2008 Dodge Ram 1500 4x4 was brought to us when its owner noticed that his trailer was causing his rear suspension to bottom out while negotiating the rough terrain of his job sites. He wanted to save his shocks the wear and damage from such rigorous use and the DR1525H4 Timbren Kit for rear suspensions were the obvious answer to this problem.
We were able to install the Timbren helper springs into the Dodge Ram in about ten minutes using only a ratchet set. Upgrade your suspension and install a Timbren Kit in your pick-up truck in five simple steps.
- Raise the vehicle – Use your lift, jack or pit to give yourself room to work. Preferably, the vehicle should be raised so that the axle is able to hang freely.
- Remove existing parts – Use your ratchet set to unbolt the preexisting bump stop assembly.
- Assemble the helper spring – Assemble the Aeon rubber spring and bracket with the provided hardware. The spacer disc is only needed if the gap between the helper spring and the lower support is greater than 1 inch on ½ and ¾ ton pick-ups or ½ inch on 1 ton trucks. Important: This distance should be measured when the vehicle is unloaded.
- Mount the assembly – Bolt the assembly to the frame assuring that the bracket is flush with the frame and the helper spring lines up directly with the lower support.
- Lower vehicle – With your helper spring assembly securely fastened to the vehicle, you are ready to lower your truck and start enjoying the benefits of your newly upgraded truck suspension.